Snapper 11305, 8245, 9265 Protection for Children, Preparation, Operational Precautions

Page 2

IMPORTANT SAFETY INSTRUCTIONS

WARNING: This powerful machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply with the following instructions may result in serious injury to the operator or other persons. The owner of the snow thrower must understand these instructions and, furthermore, must allow only persons who understand these instructions to operate snow thrower. Each person operating the snow thrower must be of sound mind and body and must not be under the influence of any substance which might impair vision, dexterity, or judgment. If you have any questions pertaining to your snow thrower which your dealer cannot answer to your satisfaction, call or write the Customer Service Department at SNAPPER, McDonough, Georgia 30253. Phone: 800/935-2967.

PROTECTION FOR CHILDREN

Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the machine and the snow removal activity. Never assume that the children will remain where you last saw them.

1.DO NOT allow children in the area when snow thrower is being operated.

2.DO NOT allow pre-teenage children to operate snow thrower.

3.ALLOW only responsible adults and teenagers with mature judgment to operate the machine and then only after being thoroughly instructed and under the close supervision of an experienced adult operator.

4.Keep the area clear of all persons, particularly small children and pets.

5.Know how to STOP the snow thrower and disengage the controls quickly.

PREPARATION

(Continued From Previous Column)

7.Survey the area to be cleared beforehand and plan where snow is to be blown. Be prepared to release auger/impeller clutch or to change discharge chute direction quickly to discharge away from windows, cars, buildings and doorways to avoid property damage or personal injury from hurled objects.

8.Use only approved extension cords and receptacles in good condition and with sufficient capacity to carry the current to the machine if equipped with electric starting motors.

9.Handle fuel with extra care. Fuels are flammable and vapors are explosive. Store only in an approved fuel container. Never remove fuel cap or add fuel with the engine running. Add fuel outdoors only with the engine stopped and cool. Clean spilled fuel and oil from machine. DO NOT smoke. DO NOT run engine indoors.

PREPARATION

1.Warn everyone in advance to stay clear of area. Keep especially watchful for children and pets darting into area while operating.

2.Read, understand, and follow instructions and warnings in this manual and on the machine. Know the controls and the proper use of the snow thrower before starting.

3.Data indicates that operators, age 60 and above, are involved in a large percentage of snow thrower-related injuries. These operators should evaluate their ability to operate the snow thrower safely enough to protect themselves and others from serious injury.

4.Disengage all clutches and shift into neutral before starting the engine (motor).

5.Wear adequate winter clothing including boots which will give you maximum footing on slippery surfaces. Exercise CAUTION to avoid slipping or falling.

6.Before the first snow fall, check the area to be cleared and remove all objects such as doormats, sticks, toys, wires, rocks, etc., which could be hurled or jam the snow thrower

OPERATIONAL PRECAUTIONS

1.Before starting, make visual check to make sure auger/impeller housing is clear and all guards and shields are in place and tight.

2.DO NOT operate machine without proper guards shields, deflectors, or other safety protective devices in place and functioning properly.

3.Should the auger/impeller become clogged, release the auger/impeller clutch control and, as an additional precaution, STOP the engine before attempting to unclog the auger/impeller or discharge chute.

4.DO NOT attempt to unclog the auger/impeller or discharge chute by reaching in with your hands. Use a long stick or similar implement to unclog.

5.DO NOT attempt to unclog the auger/impeller or discharge chute with the engine running. STOP engine and remove key.

6.STOP engine (motor) and remove key before leaving the operator position for any reason.

2

Image 2
Contents Manual No -8225 REV .1, 10/25/02 Model Number ExplanationEngine HP Series Designation Auger Width Preparation Operational PrecautionsProtection for Children Maintenance and Storage Table of Contents Introduction NomenclatureMinimum Gauge for Cord Sets PRE-START Check ListSTARTING, Operation & Stopping Recoil Start Models Go to Page 9 for Electric Start Models EngineEngaging Wheel Drive Discharge Chute and Deflector AdjustmentEngaging Auger STARTING, Operation & Stopping Electric Start Models Stopping ENGINE, Auger & Wheel Drive Free Wheel MachineGear CASE, Auger Shaft and Auger Bearing Lubrication Service After First 5 Hours Check Auger Drive BeltGeneral Lubrication Check Wheel Drive BeltAnnually END of Each Season Storage ProcedureMaintenance and Service Parts Engine Spark PlugAuger and Wheel Drive Cable Adjustment Auger Belt Idler Pulley AdjustmentRecheck cable for proper extension 3/8 Reinstall belt cover Repair & Adjustments Skid Shoe Adjustment Single Handle Control Adjustment Chute Crank Adjustment Rubber Drive Tire Replacement100 Problem Probable Cause Corrective ActionService Performed Each USE HRS SeasonYear Limited Warranty Disclaimer of WarrantyPage Page Page TWO Stage Large Frame Snow Thrower Series Instruction No -8225 REV .1, 10/25/02
Related manuals
Manual 28 pages 34.11 Kb