Snapper 8245 TWO Stage Large Frame Snow Thrower Series, Instruction No -8225 REV .1, 10/25/02

Page 24

Safety Instructions & Operator’s Manual for

TWO STAGE

LARGE FRAME

SNOW THROWER

SERIES 5

IMPORTANT

Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions information and critical safety warnings. Read, Understand, and Follow all warnings and instructions in this manual, the engine manual, and on the machine, engine and attachments. If you have any questions about your Snapper product, contact your local authorized Snapper dealer or contact Snapper Customer Service at Snapper, McDonough, GA. 30253. Phone: (1-800-935-2967).

WARNING

BATTERY POSTS, TERMINALS AND RELATED ACCESSORIES CONTAIN LEAD AND LEAD COMPOUNDS, CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER HANDLING.

WARNING

ENGINE EXHAUST, SOME OF ITS CONSTITUENTS, AND CERTAIN VEHICLE COMPONENTS CONTAIN OR EMIT CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER OR OTHER REPRODUCTIVE HARM.

COPYRIGHT © 2000

SNAPPER INC.

ALL RIGHTS RESERVED

INSTRUCTION No. 2-8225 (REV. 6.1, 10/25/02)

24

Image 24
Contents Model Number Explanation Engine HP Series Designation Auger WidthManual No -8225 REV .1, 10/25/02 Operational Precautions Protection for ChildrenPreparation Maintenance and Storage Table of Contents Introduction NomenclatureMinimum Gauge for Cord Sets PRE-START Check ListSTARTING, Operation & Stopping Recoil Start Models Go to Page 9 for Electric Start Models EngineDischarge Chute and Deflector Adjustment Engaging AugerEngaging Wheel Drive STARTING, Operation & Stopping Electric Start Models Stopping ENGINE, Auger & Wheel Drive Free Wheel MachineService After First 5 Hours Check Auger Drive Belt General LubricationGear CASE, Auger Shaft and Auger Bearing Lubrication Check Wheel Drive BeltStorage Procedure Maintenance and Service PartsAnnually END of Each Season Engine Spark PlugAuger and Wheel Drive Cable Adjustment Auger Belt Idler Pulley AdjustmentRecheck cable for proper extension 3/8 Reinstall belt cover Repair & Adjustments Skid Shoe Adjustment Single Handle Control Adjustment Chute Crank Adjustment Rubber Drive Tire ReplacementProblem Probable Cause Corrective Action Service Performed Each100 USE HRS SeasonYear Limited Warranty Disclaimer of WarrantyPage Page Page TWO Stage Large Frame Snow Thrower Series Instruction No -8225 REV .1, 10/25/02
Related manuals
Manual 28 pages 34.11 Kb