Section 2 - OPERATING INSTRUCTIONS
2.1
Make the following checks and perform the service required before each
WARNING
DO NOT use an electrical extension cord that is damaged. A damaged electrical extension cord could cause a shock or fire. Thoroughly inspect electrical extension cord before using machine. If cord is damaged, do not use and do not operate machine. Replace damaged cord immediately. Contact your SNAPPER service dealer for assistance. To reduce the risk of electric shock, use only with an extension cord intended for outdoor use having a cord type:
2.1.7.Check and make sure extension cord is in good condition. Extension cord should not have any broken insulation or exposed wires. Use an extension cord that is heavy enough to carry the correct amount of current to the machine. See Figure 2.3 for correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge cord.
MINIMUM GAUGE FOR CORD SETS
120 Volt | Total Length of Cord in Feet | ||||
Rating - Amps | 25 ft. | 50 ft. | 100 ft. | 150 ft. | |
More | Not More |
| A.W.G. |
| |
Than | Than |
|
| ||
|
|
|
| ||
0 | 6 | 18 | 16 | 16 | 14 |
6 | 10 | 18 | 16 | 14 | 12 |
10 | 12 | 16 | 16 | 14 | 12 |
12 | 16 | 14 | 12 | Not | |
|
|
|
| Recommended | |
FIGURE 2.3
2.1.8.Check the AC electrical outlet that will be used and make sure it is a polarized outlet. The machine has a polarized plug (one blade of plug is wider than the other blade) that will accept a polarized extension cord. The extension cord will fit into a polarized outlet (receptacle) only one way. If plug does not fit fully into your outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper polarized outlet. DO NOT modify or change this polarized plug in any way.
IMPORTANT! Electric Start Kit optional accessory on some models.
6