Installation
Broadmoor/LT/1600/2600 Series &
Landlord/GT/1700/2700 Series
1.Drive the tractor over the push bar until rear of push bar is under front hitch.
2.Stop engine, remove key and set parking brake.
3.See Figure 10. Position the push bar hitch (A) into the tractor frame brackets (B). Secure push bar with pin (C) and safety clip (D).
Figure 10. |
|
A. Push Bar Hitch | C. Hitch Pin |
B. Frame Bracket | D. Safety Clip |
Regent/500/2500 Series Only:
1.Drive the tractor over the push bar until the rear of the push bar is positioned between the side rail extensions on the front of the hitch.
2.Stop engine, remove key and set parking brake.
3.See Figure 11. Align the mounting holes in the rear corners of the push bar (A) with the mounting holes in the hitch (B), and secure the push bar to the hitch with a clevis pin (C), and spring clip (D) at each corner.
C
D
B
| A |
|
|
Figure 11. |
|
A. Push Bar | C. Clevis Pin |
B. Hitch | D. Spring Clip |
| (Not shown) |
10