Assembly
All Models
1.Place the blade on a flat surface.
2.Regent/500/2500 & Broadmoor/LT/1600/2600 Series: See Figure 4. Install one bar stop (A) using the two
Landlord/GT/1700/2700 Series: Do not install bar stops.
Figure 4. Bar Stop
A. Bar Stop
B. Taptite Screw, 5/16-18 x 1
3.See Figure 5. Insert threaded end of eyebolt (A) thru lug on blade, and screw on 5/16 nut (B) just far enough so that it is flush with the end of the eyebolt.
4.See Figure 5. Hook the springs (C) into the pivot frame (D). Using a pliers, stretch the springs to hook the opposite ends to the eyebolts (A).
5.See Figure 5. Tighten the nut (B) on each eyebolt enough to expose about 3/4" (19 mm) of thread.
6.See Figure 5. Holding the first nut (B) with a wrench,add a second nut (E) to each eyebolt, and tighten securely against the first nut to act as a jam nut.
Figure 5. Tension Springs |
|
A. Eyebolt | D. Pivot Frame |
B. Nut, 5/16 | E. Nut, 5/16 |
C. Spring |
|
7