L.H. LIFT PIVOT
MOUNT PLATE
LIFT ASSEMBLY
PIVOT SHAFT
HITCH BRACE
FIGURE 14
15.Assemble the other lift pivot plate, over right hand end of lift assembly pivot shaft and connect to outside of frame (see figure 15) using one 3/8" x 1" clevis pin from inside through front hole in lift pivot plate. Secure with 3/8" flat washer and 3/32"" (small) hairpin cotter. Secure rear of plate with one 3/8" x 3/4" clevis pin and one 3/32" (small) hairpin cotter. Secure ends of pivot shaft to each lift pivot plate
with 1/8" (large) hairpin cotter. See figures 14 and 15.
3/32"" |
| 318"" X 3/4'" CLEVIS PINS |
HAIRPIN |
|
|
_ | 3/8" | |
| J | ._ FLAT WASHER |
LI
ROD | , |
|
|
LIFT ASS'Y. | _ | LIFT PIVOT | |
PIVOT SHAFT |
| MOUNT PLATE | |
RIGHT | HAND SIDE VIEW |
| FRONT |
FIGURE | 15 |
|
|
16.Assemble the front end of each hitch brace to the rear hole in each hitch plate using one 1/2" x
HITCH" PLATE
HAIRPIN COTTER
1" OD SPACER | 1/_'; x |
HITCH BRACE | CLEVIS PIN |
FIGURE 16 |
|
17.Assemble guide bracket assembly shaft end into the left hand hitch plate. See figure 17. Slide guide assembly back to the right and into hole of the right hand hitch plate. Secure with a 1/8" (large) hairpin cotter in each end. See figure 17.
Lower front end of guide bracket assembly to straddle channel assembly.
_ | I FRONT | PIVOT SHAFT | |
| HITCH | ! | |
PLATE (R.H.) I |
| HAIRPI_I_coTTER | |
• |
|
| i |
• | T |
[ PLATE''/'GUIDE' BRAICKET' | ASS,Y. | HITC(L H ) |
FIGURE 17