18.Raise hood and remove 3/8" carriage bolt and nut from right hand side of frame. See figure 18.
LIFT
LEVER
. PLUNGER
REMOVE FRONT
CARRIAGE BOLT
AND NUT
RIGHT SIDE VIEW
FIGURE 18
!9. Assemble support bracket onto right hand side of tractor frame (where carriage bolt was removed in step 15) using 3/8" x 1"" carriage bolt inside of frame and secure with 3/8" lock washer and 3/8" hex nut, on outside of frame.
See figure 19.
ATTACHMENTLIFT LEVER FRONT---_
23.Secure one end of blade lock release cable to small hole in blade lock release lever using one
3/8" x 3/4" clevis pin and one 3/32" hairpin cotter• See figure 20.
BLADE LOCK
RELEASE LEVER
3/8" x 1"
HEX BOLT
D
CLEVIS PIN
COTTER PIN
SPACER FLAT WASHER
3/8" HEX LOCK NUT
FIGURE 20
24. Thread cable toward front of tractor under steering tie rod and front axle and above guide
LIFT LEVER
PLUNGER
BLADE PIVOT
bracket assembly• See figure 21.
1/4" HEX LOCK ROD
25.Assemble one 3/8" x
3/8"'x | 1" |
|
CARRIAGE | EYE BOLT | |
BOLT | HAIRPIN | |
3/8" | LOCK | COTTER |
WASHER | 3/8" HEX NUT | |
|
| RIGHT SIDE VIEW |
FIGURE | 19 |
|
20.Assemble the 1/4" eye bolt at the top of the support bracket and secure with one 1/4'" hex
. lock nut. See figure 19.
21.Assemble blade pivot rod through 1/4" eye bolt as shown in figure 19. Secure lower end of blade pivot rod through hole on right hand side of blade assembly with small hairpin cotter. See figure 19.
22.Assemble blade lock release lever to right side of tractor frame using one
RIGHT SIDE VIEW | FRONT | . |
SUPPORT BRACKET
3/8"" x
NUTS (2)
il
STEERING
TIE ROD
FREE END
CHANNELOF CABLE
ASS'Y.
GUIDE BRACKET
ASS'Y.
FIGURE 21
Q