This same lever also locks the auger control so you can turn the chute directional control without interrupting the snow throwing process. If the auger control is engaged along with the traction control, the operator can release the auger control (on the left handle) and the augers will remain engaged. Release the traction control to stop both the augers and track drive (auger control must also be released).
IMPORTANT: Always release tractional control before changing speeds.
Auger Drive Control
The auger drive control is located on the left handle. Squeeze the control grip to engage the augers. Release to stop the snow throwing action. (Traction control must also be released.) See Figure 5.
Chute Tilt Control
The distance snow is thrown can be changed by adjusting the angle of the chute assembly. Move the chute tilt control forward to decrease the distance, toward the rear to increase. See Figure 5.
Skid Shoe
The position of the skid shoe is determined by the condition of the ground from where snow has to be removed. See Figure 5.
Shift Lever
The shift lever is located in the center of the handle panel and is used to determine both ground speed and direction of travel. It can be moved into any of eight positions. See Figure 5.
Forward
Your snow thrower has six forward (F) speeds. Position number one (1) is the slowest. Position number six (6) is the fastest.
Reverse
Your snow thrower has two reverse (R) speeds. R1 is the slower, while R2 is the faster of the two.
IMPORTANT: Always release tractional control before changing speeds.
Chute Directional Control
The chute directional control is located on left side of the snow thrower. See Figure 5.
To change the direction in which snow is thrown, turn chute directional control as follows:
•Crank clockwise to discharge to the left.
•Crank counterclockwise to discharge to the right.
Chute Clean-Out Tool
The chute
WARNING: Never use your hand to clear a clogged discharge chute. Shut off engine and remain behind handles until all moving parts have stopped before unclogging.
Heated Handles Switch
This switch is located on the right side of the snow thrower dash panel. To activate the heated handles, toggle the switch to the right to generate heat within the handle grips. Toggle the switch to the left to the OFF position after using the snow thrower. See Figure 5.
NOTE: The heated handles grips are a compliment to, not a substitute for, proper cold weather outerwear for the operator’s hands. It is recommended that the snow thrower operator wear gloves/mittens to avoid extremities of winter while operating this equipment.
Track Steering Controls
The left and right track steering controls are located on the underside of the handles and they are used to assist in steering the snow thrower. Squeeze the right track control when turning right, squeeze the left control when turning left. Operate your snow thrower in open areas until you become familiar with these controls. See Figure 5.
NOTE: It is easier to maneuver a
Throttle Control
The throttle control is located on the engine. It regulates the speed of the engine and will shut off the engine when pushed down completely. See Figure 5.
Fuel Shut-Off Valve (Optional Equipment)
On models so equipped, the fuel
Safety Ignition Key
The safety ignition key must be fully inserted in the switch before the unit will start. Remove the ignition key when the snow thrower is not in use. See Figure 5.
IMPORTANT: Do NOT attempt to turn the key.
Headlight
The headlight is on whenever the engine is running.
7