Installation Instructions
Sheet 1 of 3
Vault |
|
| Roundel |
These installation instructions are valid with the above Ametrix styles.
Large, INDOOR
P1R
(Pendant,
Visor and Non-Visor
Warning: Before starting any work ensure that all sources of power are turned off. All work must meet local/national codes and be performed by a certified electrician. Do not mount fixtures vertically.
Exploded view and part call-out
1Securing fixture to pendant
Mounting plate | Appropriate fasteners |
| (by others) |
| (2x) |
Wire ways | |
| Pan head screw |
Canopy | (2x) |
| |
| |
End screw |
|
(2x) |
|
| |
| Hex cap screw |
Wire connector
End cap
End screw (2x)
Mounting plate
Yoke
Fixture wire
(2x) |
Attention:
Large fixtures require additional bracing/structure
around J-box to support fixture..
2Mounting and wiring fixture
Use additional bracing | |
(by others) | around |
| fixture. |
Appropriate | |
fasteners | Pan head screws |
(by others) | (2x) |
(4x) |
|
Canopy |
|
1.Loosen
2.Feed wires from
3.Attach appropriate wires and ensure all connections are properly matched.
4.Replace canopy and secure with both
1.Begin by removing end screw,
2.Mount yoke to pendant with both
3.Feed fixture wire through connector in pendant up through mounting plate and reattach fixture head to yoke.
3Aiming the fixture
Yoke arm | Fixture head |
indicator | indicator |
1.To aim fixtures, loosen both
fixture. When both indicators are lined up, the slope of the lens face is
2.When fixture head is rotated to the desired angle, retighten end screws to secure the position.
ADY071470 REV A(ECN070347)