IBM 388, 387, 393, 391, 389, 441, 390 Installing a non-hot-swap hard disk drive, What to do next

10.Align the top edge of the EMI-protective panel with the top side of the hard disk drive cage and then pivot the EMI-protective panel down until it snaps into position.

Figure 65. Installing the EMI-protective panel

11.Disconnect the SATA cable for the removed non-hot-swap hard disk drive from the system board and save the cable for future use.

12.Close and lock the front door.

13.If you are instructed to return the old non-hot-swap hard disk drive, follow all packaging instructions and use any packaging materials that are supplied to you for shipping.

What to do next:

•To work with another piece of hardware, go to the appropriate section.

•To complete the removal procedure, go to “Completing the parts replacement” on page 162. Then, you might need to reconfigure RAID for your server. See “Configuring RAID” on page 71.

Installing a non-hot-swap hard disk drive

Attention: Do not open your server or attempt any repair before reading and understanding the “Safety information” on page iii and “Guidelines” on page 83.

This topic provides instructions on how to install a non-hot-swap hard disk drive.

Before you begin, consider the following hard disk drive installation rules:

•Follow the order of the hard disk drive bays when installing a hard disk drive. See “Server components” on page 25 to locate the hard disk drive bays in your server.

•For RAID configuration, the hard disk drives must be the same type with the same capacity if they are within a single RAID array. For more information, see “Configuring RAID” on page 71.

128ThinkServer User Guide