IBM 387, 393, 391, 389, 388, 441, 390, 392 manual Connect the appropriate power cable hard disk drive

10.Connect the appropriate power cable hard disk drive.

1

and the SATA signal cable

2

to the rear of the non-hot-swap

Figure 69. Connecting cables to the rear of the non-hot-swap hard disk drive

The following table provides information about the recommended power connector and system board SATA connector for the non-hot-swap hard disk drive installed in each drive bay. See “Server components” on page 25 and “System board components” on page 42 for the location information about the hard disk drive bays and SATA connectors on the system board.

Non-hot-swap hard disk drive	Power connector	System board SATA connector
Installed in bay 0	P9 power connector	SATA connector 0
Installed in bay 1	P10 power connector	SATA connector 1
Installed in bay 2	P7 power connector	SATA connector 2
Installed in bay 3	P8 power connector	SATA connector 3

11.Connect the other end of the SATA signal cable to the appropriate SATA connector on the system board. See “System board components” on page 42.

12.Reinstall the front system fan 1. See “Replacing the front system fan” on page 149.

132ThinkServer User Guide