IBM 441, 387, 393, 391 Removing the Ethernet card, What to do next, Expand the Network adapters

Before you begin, print all the related instructions or ensure that you can view the PDF version on another computer for reference.

Note: Use any documentation that comes with the Ethernet card and follow those instructions in addition to the instructions in this topic.

To install the Ethernet card, do the following:

1.Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the server.

2.Remove the server cover. See “Removing the server cover” on page 85.

3.Lay the server on its side for easier operation.

4.Locate an appropriate PCI card slot on the system board for installing the Ethernet card. You can install the Ethernet card to the PCI-E slot 2 or PCI-E slot 3 that supports a card with 167 mm (6.57 inches) in length. See “System board components” on page 42 to identify the different types of PCI card slots in your server.

5.Remove any parts or disconnect any cables that might impede your operation.

6.Touch the static-protective package that contains the Ethernet card to any unpainted surface on the outside of the server. Then, take the Ethernet card out of the package.

Note: Carefully handle the Ethernet card by its edges.

7.The Ethernet card is a kind of PCI card. See “Installing a PCI card” on page 93 and follow those instructions to install the Ethernet card.

What to do next:

•To work with another piece of hardware, go to the appropriate section.

•To complete the installation, go to “Completing the parts replacement” on page 162. Then, continue with the following procedure to install the Ethernet card driver if you are using a Windows operating system. On Linux operating systems, you do not need to install any device driver for the Ethernet card.

On Windows operating systems, do the following to install the device driver for the Ethernet card:

1.Save any open documents and exit all applications.

2.Click Start. Rright-click My Computer and select Properties. The System Properties window opens.

3.Click the Device Manager button on the Hardware tab. The Device Manager window opens.

4.Expand the Network adapters.

5.Right-click one of the Ethernet cards (PRO/1000PT or the yellow question mark).

6.Select Update Driver. The Hardware Update Wizard window opens. You will be asked if you permit Windows to connect to Windows Update to search for software.

7.Make a selection depending on your needs and click Next.

8.Insert the ThinkServer EasyStartup DVD that comes with your server into the optical drive. Note: You do not need to use the driver disc that comes with the Ethernet card.

9.Select Install the software automatically (Recommended) and click Next to continue.

10.Follow the instructions on the screen to complete the installation.

Removing the Ethernet card

Attention: Do not open your server or attempt any repair before reading and understanding the “Safety information” on page iii and “Guidelines” on page 83.

Chapter 6. Installing, removing, or replacing hardware 97