IBM 391, 387, 393, 389, 388, 441 Remove the server cover. See “Removing the server cover” on page

3.The non-hot-swap hard disk drive(s) are installed in the lower hard disk drive cage and are protected by an EMI-protective panel. Press the small tab 1 on the EMI-protective panel from the bottom and then pivot the EMI-protective panel upward to remove it from the chassis and gain access to the non-hot-swap hard disk drive(s).

2 1

CPU

MEM

PSU

Figure 63. Removing the EMI-protective panel

4.Remove the server cover. See “Removing the server cover” on page 85.

5.Remove the front system fan 1. See “Replacing the front system fan” on page 149.

6.Locate the appropriate non-hot-swap hard disk drive. See “Server components” on page 25. Then, disconnect the SATA signal cable and the power cable from the rear of the non-hot-swap hard disk drive.

126ThinkServer User Guide