IBM 387, 393, 391, 389, 388, 441, 390, 392 manual Updating the server configuration

5. Slide the server cover to the front of the chassis until it snaps into position.

Figure 100. Installing the server cover

6.Tighten the thumbscrew on the server cover to secure the server cover in place.

Note: For safety consideration, be sure to use a tool, for example a screwdriver, to tighten the thumbscrew and always make sure that the thumbscrew is securely installed. Also, do not over-tighten the thumbscrew.

7.Lock the server cover and server front door to ensure the security. See “Server locks” on page 22.

8.Reconnect external cables and power cord(s) to the server. See “Rear view of the server” on page 19 to identify the connectors on the rear panel of the server.

Attention: To avoid component damage, connect the power cord(s) last.

Note: In most areas of the world, Lenovo requires the return of the defective CRU. Information about this will come with the CRU or will come a few days after the CRU arrives.

Updating the server configuration

When you turn on the server for the first time after you install, remove, or replace a device, you might need to update the server configuration.

Some optional devices have device drivers that you must install. For information about installing device drivers, use the documentation that comes with each optional device. To obtain the supported device drivers for your server from the Lenovo Support Web site, go to http://www.lenovo.com/support. Click Download & Drivers ➙ ThinkServer and follow the instructions on the Web page to find the device drivers you want to download.

Refer to the following information resources to update the server configuration:

•To update the BIOS configuration, see “Using the Setup Utility program” on page 55.

•To update the RAID configuration, see “Configuring RAID” on page 71.

164ThinkServer User Guide