IBM 392, 387, 393, 391, 389, 388, 441, 390 manual Note Do not touch the circuit board

8.Install the new non-hot-swap hard disk drive into a blue bracket by flexing the sides of the bracket and aligning pin 1 , pin 2 , pin 4 , and pin 5 on the bracket with the corresponding holes in the hard disk drive so that the hard disk drive can be seated in the bracket.

Note: Do not touch the circuit board

3

on the bottom of the hard disk drive.

Figure 68. Installing the non-hot-swap hard disk drive into the bracket

9. Slide the new non-hot-swap hard disk drive with bracket into the drive bay until it snaps into position.

Chapter 6. Installing, removing, or replacing hardware 131