|
| Service |
6. Reverse the procedure to install the belts. Be sure |
|
|
there are no twists and the belts are properly seated |
|
|
in the grooves. Adjust the belt stops so there is 1/8” |
|
|
(3mm) clearance between belt and stop. The pattern |
|
|
for both belts is shown in Figure 31. Slide the right |
| E |
axle left fully before tightening the set collar (E, | D |
|
Figure 30). | C | |
7. Check the traction drive tension and auger drive ten- |
| |
|
| |
sion. Follow the procedures under AUGER/TRAC- |
|
|
TION DRIVE TENSION. |
|
|
8. Make sure the auger stops when the auger drive | B | B |
lever is released. Make sure traction drive stops |
|
|
when the traction drive lever is released. If not, check |
|
|
the drive tension. If a problem exists, see your dealer. | A | A |
| Figure 30. Auger Pulley Belt Stops |
|
| (shown with bottom cover removed) |
|
| A. Nuts |
|
| B. Belt Stops |
|
| C. Auger Pulley |
|
| D. Gear Assembly. Bolts |
|
| E. Set Collar |
|
E
E
C
D
A
B
F
F
Figure 31. Belt Pattern (viewed from front) A. Engine Pulley
B. Drive Belt
C. Idler Pulley D. Driven Pulley
E. Engine Belt Stops
F. Auger Pulley Belt Stops
27