Yard Machines 961940001 Assembly / Pre-Operation, INSTALL AUGER CONTROL ROD See Figs. 5 and

Page 6
INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)

ASSEMBLY / PRE-OPERATION

INSTALL TRACTION DRIVE CONTROL ROD (See Figs. 3 and 4)

The traction drive control rod has the long loop on the end of the spring as shown.

1.Slide rubber sleeve up rod and hook end of spring into pivot bracket with loop opening down as shown.

2.With top end of rod positioned under left side of control panel, push rod down and insert top end of rod into hole in drive control bracket. Secure with retainer spring.

TRACTION DRIVE

CONTROL ROD

RUBBER

SLEEVE

LOOP

OPENING

DOWN

PIVOT

BRACKET

FIG. 3

TRACTION DRIVE

RETAINER

CONTROL LEVER

SPRING

TRACTION

DRIVE

CONTROL

ROD

DRIVE

CONTROL

BRACKET

FIG. 4

INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)

The auger control rod has the short loop on the end of the spring as shown.

1.Slide rubber sleeve up rod and hook end of spring into control arm with loop opening up as shown.

2.With top end of rod positioned under right side of control panel, push down on rod and insert end of rod into hole in auger control bracket. Secure with retainer spring.

AUGER

CONTROL

ROD

RUBBER

SLEEVE

CONTROL

ARM

LOOP

OPENING

UP

FIG. 5

AUGER CONTROL ROD

AUGER

RETAINER

CONTROL

LEVER

SPRING

 

AUGER

CONTROL

BRACKET

FIG. 6

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents 961940001 SNOW THROWERIMPORTANT MANUAL Do Not Throw AwayTraining PreparationOperation Clearing a Clogged Discharge Chute TABLE OF CONTENTSMaintenance and Storage PRODUCT SPECIFICATIONSPARTS PACKED SEPARATELY IN CARTON REMOVE SNOW THROWER FROM CARTON ASSEMBLY / PRE-OPERATIONHOW TO SET UP YOUR SNOW THROWER INSTALL SPEED CONTROL ROD See Figs. 1 andINSTALL AUGER CONTROL ROD See Figs. 5 and CHECK TIRE PRESSURE OPERATION KNOW YOUR SNOW THROWERMEETS A.N.S.I. SAFETY REQUIREMENTS STOPPING HOW TO USE YOUR SNOW THROWERTO USE CHOKE CONTROL See Fig TO USE FUEL SHUT-OFFVALVE See FigTO THROW SNOW See Fig USING THE CLEAN-OUTTOOL See FigPOWER STEERING OPERATION See Fig. TO MOVE FORWARD AND BACKWARD See FigSCRAPER BAR BEFORE STARTING THE ENGINETO ADJUST SKID PLATES See Fig TO USE DRIFT CUTTERS See FigBEFORE STOPPING SNOW THROWING TIPSTO START ENGINE IF RECOIL STARTER HAS FROZENGENERAL RECOMMENDATIONS MAINTENANCELUBRICATION CHART BEFORE EACH USEV-BELTS CLEANINGENGINE AUGER GEAR CASETO ADJUST SNOW THROWER HEIGHT SERVICE AND ADJUSTMENTS2.Remove safety ignition key 1.Be sure throttle is in STOP positionTO REMOVE WHEELS See Fig CARBURETOR STORAGEOTHER ENGINE SPEEDDoes not start TROUBLESHOOTINGLoss of power Engine idles orLIMITED WARRANTY
Top Page Image Contents