SECTION 3: ASSEMBLING YOUR SNOW THROWER
IMPORTANT: After assembly, service engine with gasoline, and check oil level as instructed in the separate engine manual packed with your unit.
NOTE: References to right or left side of the snow thrower are determined from behind the unit in the operating position.
Unpacking
•Remove staples or break glue on top flaps of the carton. Remove any loose parts included with unit (i.e., operator’s manual, etc.).
•Cut corners of the carton and lay ends down flat. Remove packing material.
•Roll unit out of carton. Check carton thoroughly for loose parts before discarding.
•Compare Figure 1 with the list below to identify loose parts in the carton.
Ref. | Description | Qty. |
A | Handles (Right and Left) | 2 |
B | Pivot Rod | 1 |
C | Cover Tube | 1 |
D | Clutch Grips (Right and Left) | 2 |
E | Handle Panel | 1 |
F | Speed Selector Plate | 1 |
G | Shift Lever | 1 |
H | Chute Directional Control Assembly | 1 |
J | Chute Assembly | 1 |
I | Hardware Pack | 1 |
Tools Required
1. Two adjustable wrenches
Loose Parts In Carton
B C
D
E
F
A
G
H
J
Figure 1
Before Assembly
WARNING: Disconnect the spark plug wire and ground it against the engine to prevent unintended starting.
Attaching Handles
(Use Hardware Group A.)
•Place right handle in position against the snow thrower so that the flat side of the handle is against the frame. Align the bottom hole on the handle to the corresponding hole on the snow thrower housing.
•Insert hex bolt (B) and lock washer (C) through these holes to secure the handle to the snow thrower housing. See Figure 2. There are weld nuts welded to the inside of the frame for these bolts. Do not tighten now.
Hex Bolt B | Lock Washer C |
Saddle
Washer I
Hex Bolt A,
Lock Washer C
Figure 2
•Attach the left handle in the same manner. Do not tighten now.
•Place saddle washer (I) over upper holes on handles as shown in Figure 2. Secure to the frame with lock washers (C) and hex bolts (A). Do not tighten now.
6