
Flat | Chute |
Washers T | Directional |
| Control |
Hairpin Clip S
Chute Directional Control
Bracket
Figure 11
•Thread one hex nut (D) onto the eyebolt on the chute directional control assembly until there is at least two inches of threads showing between the nut and the eyebolt head. See Figure 12 inset.
•Place the eyebolt into the hole located half way up the left handle. See Figure 12. Secure with cupped washer (N) and hex nut (D) making sure that the cupped side of the washer is against the handle.
2” of thread |
Cupped
Washer N
Hex Nut D
Eye Bolt
Hex Nut D
Chute
Directional
Control
Figure 12
•Adjust the chute directional control bracket so that the spiral on the chute directional control fully engages the teeth on the chute assembly. See Figure 14. Tighten all hardware.
Spiral should engage teeth of chute here
Figure 13
•Check to make sure all nuts and bolts on the control panel and all four bolts which secure the handles to the frame are tight.
Final Assembly & Adjustments
Auger Control
•To check the adjustment of the auger control, push forward on the left hand clutch grip (depress the rubber bumper). There should be slack in the cable. Release the clutch grip. The cable should be straight. Make certain you can depress the auger control grip against the left handle completely.
•If necessary, loosen the hex lock nut and thread the cable in (for less slack) or out (for more slack) as necessary. Refer to Figure 14.
•Tighten the lock nut against the cable when correct adjustment is reached.
“Z” Fitting
Hex Bolt
Cable
Figure 14
9