Cub Cadet 31AH4Q3G100 manual Assembling Your Snow Thrower, Unpacking, Loose Parts, Assembly

Page 5

SECTION 2: ASSEMBLING YOUR SNOW THROWER

NOTE: Any reference in this manual to the left or right side of the snow thrower is observed from the operator’s position.

Unpacking

Remove staples from the top sides and ends of the shipping crate.

Set panel aside to avoid tire punctures or personal injury.

Remove and discard plastic bag that covers unit.

Remove any loose parts included with unit (i.e., Operator’s Manual, etc).

Roll unit out of crate.

Loose Parts

The augers are secured to the auger shaft with two shear bolts and hex lock nuts. If you hit a foreign object or ice jam, the snow thrower is designed so that the bolts may shear. Two replacement shear bolts and nuts are provided for your convenience. Store in a safe place until needed. See Figure 1.

Shear Bolts

 

Hex Lock

 

 

 

Nuts

Figure 1

Assembly

WARNING: Disconnect the spark plug wire and ground it against the engine to prevent unintended starting.

Remove the lower two plastic wing nuts, cupped washers and carriage bolts from each side of the lower handle. See Figure 2.

Lower

Handle

Handle

Panel

 

Upper Handle

 

Wing Nuts,

 

Washers, & Bolts

Figure 2

Raise the upper handle assembly until it locks over the lower handle.

Look at lower rear of snow thrower frame to be sure both cables are aligned with cable roller guides. See Figure 3.

Cable Roller

Guides

Figure 3

Secure the upper handle and lower handle with the two plastic wing knobs, cupped washers and carriage bolts previously removed and tighten the upper two plastic wing nuts. See Figure 4.

Upper

Shift Rod

Shift Rod

Connector

Lower

Shift Rod

Wing Nuts

Figure 4

Slide the shift rod connector down over the end of the lower shift rod. Tap the connector until it locks on the lower shift rod. See Figure 4.

NOTE: If the connector is not properly assembled, the shift rod will pivot and you will not be able to shift gears or change directions.

If not already attached, slip the cables that run from the handle panel to the chute into the cable guide on top of the engine. See Figure 5.

5

Image 5
Contents OPERATOR’S Manual Table of Contents Training Important Safe Operation PracticesPreparation OperationMaintenance And Storage Assembling Your Snow Thrower AssemblyUnpacking Loose PartsAuger Control Adjustment Final AdjustmentsTraction Control and Shift Lever Adjustment Skid Shoe AdjustmentTire Pressure Know Your Snow ThrowerOperating Your Snow Thrower Electric Starter To Start EngineRecoil Starter To Stop EngineAuger Control Adjustment Skid Shoe AdjustmentChute Assembly Adjustment Traction Control AdjustmentLubrication Shift Rod AdjustmentMaintaining Your Snow Thrower Servicing Your Snow Thrower Belt Removal And ReplacementEngine AugersDrive Belt Servicing Friction Wheel Rubber Off-season Storage Trouble Possible Causes Corrective Action Trouble Shooting GuideDescription Model H4Q3GModel H4Q3G Description Model H4Q3G 22 -0473 Sprocket 714-0104 Cotter Pin 714-0474 716-0102 Model H4Q3G Model H4Q3G For Reference Only Part Description Page Page MANUFACTURER’S Limited Warranty for