Cable Guide |
Figure 5
Final Adjustments
Auger Control Adjustment
Check the adjustment of the auger control as follows:
•Push forward on the auger control until the small rubber bumper contacts the upper handle. There should be slack in the cable. See Figure 6.
•Release the auger control. The cable should be
straight. Make certain you can depress the auger control against the left handle completely.
If adjustment is necessary, proceed as follows:
•Loosen the jam nut and thread the cable in (for less slack) or out (for more slack) as necessary. See Figure 6.
•Recheck the adjustment before retightening the jam nut against the cable.
Auger |
Control |
Jam Nut |
Auger |
Control Cable |
Figure 6
Traction Control and Shift Lever Adjustment
To check the adjustment of the traction control and shift lever, proceed as follows:
•Move the shift lever into sixth (6) position.
a.With the traction control (refer to Figure 8) released, squeeze in triggers and gently push the snow thrower forward, then pull it back. Disregarding the overall weight of the
snow thrower, the machine should otherwise move freely.
b.Engage the traction control and attempt to move the machine both forward and rearward. You should experience resistance as the wheels should not be turning.
•Move the shift lever into the fast reverse (R2) position and repeat the previous steps (a & b).
If you experienced resistance either when repositioning the shift lever from 6 to R2 or when attempting to move the machine forward or rearward with the traction control released, your snow thrower’s traction control is in need of adjustment and you should NOT operate the machine before completing the adjustment as follows:
•Loosen the jam nut on the traction control cable and UNTHREAD the cable one full turn.
•Recheck the adjustment.
•Retighten the jam nut to secure the cable when correct adjustment is reached.
If the machine can be moved freely both forward and rearward when the traction control fully depressed, proceed as follows:
•Loosen the jam nut on the traction drive cable and THREAD the cable in one full turn.
•Recheck the adjustment and repeat adjustment as necessary.
•Retighten the jam nut to secure the cable when correct adjustment is reached.
NOTE: If you are uncertain that you have reached the correct adjustment, refer to Traction Control Adjust- ment in Adjustment Section.
Skid Shoe Adjustment
The space between the shave plate and the ground can be adjusted by repositioning the skid shoes found on either side of the snow throwers auger housing. For close snow removal, place skid shoes in the low position. Use middle or high position when area to be cleared is uneven. See Figure 7.
IMPORTANT: It is NOT recommended that this snow thrower be operated on a gravel surface, as loose stones can be easily picked up and thrown by the machine. If you must operate on a gravel surface, ALWAYS adjust the skid shoes into the HIGH position to allow the shave plate maximum clearance.
Adjust skid shoes as follows:
•Loosen, but do NOT remove, the three hex nuts which fasten the skid shoe to the auger housing.
•Raise or lower the skid shoe to desired position.
NOTE: Make certain the entire base of both skid shoes are against the ground to avoid uneven wear on the skid shoes. When one side does wear out, the skid shoes are reversible.
6