Wheel Steering Controls
The left and right wheel steering controls are located on the underside of the handles and are used to assist in steering the snow thrower.
•Squeeze the right wheel steering control when turning right; squeeze the left control when turning left.
•Operate the snow thrower in open areas until becoming familiar with these controls.
Chute Tilt Control
The distance snow is thrown can be changed by adjusting the angle of the chute assembly. Move the chute tilt control forward to decrease the distance, toward the rear to increase.
Discharge Chute
The angle of the discharge chute controls the distance that the snow is thrown. Tilt the discharge chute up for greater distance; tilt down for less distance.
Skid Shoe
The position of the skid shoe is determined by the condition of the ground from where snow has to be removed. Refer to page 7 for details.
Headlight
The headlight is on whenever the engine is running.
Throttle Control
The throttle control is located on the engine. It regulates the speed of the engine. Refer to Figure 10.
Safety Ignition Key
The safety ignition key must be fully inserted in the switch before the unit will start. Remove key when snow thrower is not in use. Do not attempt to turn the key. See Figure 10.
Recoil |
| |
Starter | Switch Box | |
Handle | ||
|
Primer
Choke
Safety
Ignition
Key
Throttle | Starter |
|
Control | Power | |
| Button | Cord |
|
| Plug |
Figure 10
SECTION 4: OPERATING YOUR SNOW THROWER
Before Starting
WARNING: Read, understand, and follow all instructions and warnings on the machine and in this manual before operating.
•The spark plug wire was disconnected for safety. Attach spark plug wire to spark plug before starting.
•Make certain the auger and traction control levers are in the disengaged (released) position.
•Check the oil and fuel levels and add if necessary. Follow related instructions in the separate engine manual packed with your snow thrower.
WARNING: Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel the machine indoors or while the engine is hot or running. Extinguish cigarettes, cigars, pipes and other sources of ignition.
To Start Engine
•Move throttle control up to FAST position. Insert
ignition key into slot. Make sure it snaps into place. Do not turn key.
NOTE: Engine will not start unless the safety ignition key is inserted into ignition slot in the carburetor cover.
Electric Starter
WARNING: The electric starter is equipped with a grounded
•Determine that your house wiring is a
9