•Lineup openings,insertclevispinthrough
assemblyandsecurewithcotterpin. Spreadendsofcotterpinto lockin place. Seefigurebelow.
__/Universaljoint
Upper Crank Rod
•Tighten nut on eye bolt, keeping eye in line with the rod while tightening the in- side securely.
•Tighten screw in right hand upper hole.
TO INSTALL SHIFTER LEVER KNOB
•Thread the hex nut found in the parts bag onto shifter lever. Thread the shifter lever knob onto the threaded end of the shifter
lever until it is snug against the hex nut and the lip is pointed away from the en- gine. "Rghten hex nut against the bottom of the shifter lever knob. See figure below.
Hex Nut
ShifterLever
NOTE: If the cables have become discon- nected, reinstall spring as shown in figure below,
4" Lg free state
\3" Lg free state n Auger drive
Traction | _ | '_ | _ spnng |
ddvespdng._._._4 | _'_ | /, |
Tractic_ndr'we | Auger ddve |
TO ASSEMBLE SNOW CHUTE
•Tum crank assembly counterclockwise until it stops.
•Locate three carriage bolts, flatwashers and nuts (found in parts bag) from snow chute flange. DO NOT remove carriage bolt over worm gear.
•Position snow chute on snow chute flange and align the three holes in the snow chute with holes in the snow chute flange as shown in figure below.
•Install carriage bolts from inside of chute as shown in figure below, flatwashers and nuts.
•"13ghtencarriage bolts securely. Be careful not to overt'_hten. See figure below.
•Tum crank assembly clockwise and make sure all carriage bolts are tight.
Locknut
.Snow Chute
Snow Chute Range
e Bolts
TO CHECWADJUSTCLUTCH
CONTROLCABLES
The control cables attachedto the auger clutch lever and traction clutch lever as shown in figure below may need to be ad-
justed before you use your snow thrower.
For instructions on checking or adjusting the control cables, (See To Adjust Clutch
Control Cables paragraph on page17), I
.........N