STEP19: (SEEFIGURE19)
•Attachthechutecrankrodassemblybracketsto theplasticbracketontheleftsideofthedischarge housingAlignthechutecrankbracketbeneaththe. rodsupportbracketandassemblebothtotheplastic bracketusingtwo5/16"x 1"carriagebolts,5/16" washersand5/16"Nylocknuts.Do nottightenyet.
CHUTE CRANK | 5/16" x 1" |
\\\\\\
BRACKET _ CARRIAGE BOLT
CHUTE
CRANK
ROD
SPIRAL
STEP 20: (SEE FIGURE 20)
Coat the top of the ring around the discharge opening with general purpose grease.
Place the discharge chute (facing forward) onto the ring. Place the
*Place the plastic cap onto the short end of the anti- rotation bracket.
*Position the crank rod spiral (see figure 19) so that it does not rub against the bottoms of the notches in the chute flange. Tighten the nuts.
*Check if the crank rod rotates the chute freely. If not, loosen by 1/4 turn each of the six hex bolts holding the chute keepers to the chute flange.
oSecure the control cables to the crank rod support tube using a nylon tie.
FIGURE 19 | LEFT SiDE ViEW |
FIGURE 20 | RIGHT SiDE ViEW |
STEP 21: (SEE FIGURE 21)
If the snow thrower will not lower approximately 1" below grade after it is attached to the tractor, remove the stop bolts from each side of the snow thrower frame.
STOP BOLT
FIGURE 21 | RIGHT SiDE ViEW |
13