•Assemble a shoulder bolt arid 3/8" hex lock nut to the R.H. side of the tractor fi'ame, using the first empty hole to the rear of the R.H. hanger bracket. See figure 7
Replace the engine puney keeper on your tractor with the new pulley keeper supplied with the snow blower. Attach the keeper to the frame using the original bolt, washer and nut. See figure 7.
NOTE: Some tractors may already be equipped with an identical pulley keeper.
ORIGINAL BOLT,
NUT AND WASHER
ENGAGEMENTROD
CLUTCH ARM
TRUNNION
/
5/64" HAIRPIN CO'I-rER
\
SUSPENSION ARM
FIGURE8_ | RIGHT SIDE VIE.W |
SHOULDER BOLT
R.H. HANGER BRACKET
FIGURE7 | RIGHT SIDE VIEW |
INSTALLING THE CLUTCH/IDLER ASSEMBLY ON TRACTORS WITH MANUAL ATTACHMENT
CLUTCHES (Use these instructions if your tractor has an attachment clutch lever on the dash panel for starting and stopping the mower deck.)
•Move the attachment clutch lever on the dash panel to the disengaged (down) position.
•Screw the trunnion onto the end of the engagement o
Locate the clutch arm which is found underneath
the right hand side the tractor, just to the inside of
the suspension arm. This is the arm that the mower clutch rod was connected to. This arm will move
forward and backward if the attachment clutch lever
on the dash panel is moved.
Position the engagement rod to the inside of the clutch arm and insert the drilled end of the rod
through the arm. Secure with+a 5/64" hairpin cotter. See_igure 8.
Be sure that the loose end of the engagement rod is lifted up toward the front of the tractor (as shown in figure 9) when performing the next operation.
You can temporarily support the rod using a rubber band tied to the engine pulley keeper.
Attach the snow thrower's clutch/idler assembly to the tractor frame by sliding the notched arms at the rear of the assembly onto the two shoulder botts assembled to the inside of the tractor frame. Lift the front of the assembly, fitting the sides into the R.H. and L.H. hanger brackets. Attach the assem- bly to the brackets using two pivot lock pins and 1/8" hairpin cotters. See figure 9.
1/8" HAIRPIN COTTER
PIVOT LOCK PIN
ROD
FIGURE9 | RIGHT SIDE VIEW |