OPERATION
SPARK
PLUG
SAFETY
IGNITION KEY
CHOKE
CON-
TROL
THROTTLE /
ENGINE
CONTROL
RECOIL
STARTER
HANDLE
PRIMER
NOTE: ITEMS
ABOVE ARE
SHOWN IN THEIR
TYPICAL LOCATION
ON THE ENGINE.
ACTUAL LOCATION
MAY VARY WITH THE ENGINE ON YOUR UNIT.
AUGER
ENGINE OIL CAP | AUGER |
WITH DIPSTICK | CONTROL |
| LEVER |
GASOLINE
FILLER
CAP
CHUTE
DEFLECTOR
OIL DRAIN
PLUG
FUEL
VALVE
DISCHARGE
CHUTE
DRIVE SPEED CONTROL LEVER
DISCHARGE CHUTE CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
HANDLE
KNOB
MUFFLER
TOOLBOX
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Recoil starter handle - used for starting the engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.
Choke Control - used for starting a cold engine.
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power- propelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the
direction the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
9