Husqvarna 14527E Maintenance, General Recommendations, Before Each USE, Lubrication, Snow Thrower

Page 14

MAINTENANCE

GENERAL RECOMMENDATIONS

LUBRICATION CHART

The warranty on this snow thrower does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must maintain snow thrower as instructed in this manual. Some adjustments will need to be made periodically to properly

SAE 30 Motor Oil

See “ENGINE” in

Maintenance section

maintain your snow thrower.

All adjustments in the Service and Adjustments section of this manual should be checked at least once each season.

Once a year, you should replace the spark plug and check belts for wear. A new spark plug will help your engine run better and last longer.

Follow the maintenance schedule in this manual.

NOTE: Use only Original Equipment Manufacturer (OEM) parts to service this unit. Failure to do so can cause the unit to malfunction and pose a risk of injury to the operator.

BEFORE EACH USE

1.Check engine oil level.

2.Check for loose fasteners.

3.Check controls to be sure they are functioning properly.

LUBRICATION

Keep your snow thrower well lubricated (See “LUBRICATION CHART”).

General

Purpose

Grease

Pivot points

Auger grease fittings

Engine oil

SNOW THROWER

Always observe safety rules when performing mainte- nance.

TIRES

Maintain proper air pressure in both tires (14–17 P.S.I.

Keep tires free of gasoline / oil, which can harm rubber. 14

Image 14
Contents 14527E Engine motor is running except when specifically Never attempt to make any adjustments whileThoroughly inspect the area where the equipment is Crushed rock surfaceTable of Contents EXT RA Shear Bolts and Nuts Chute Deflector Remote ControlParts Packed Separately in Carton Rotator Head MountingRemove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Unfold Upper HandleInstall Traction Drive Control ROD See Figs Install Auger Control ROD See FigsCheck Tire Pressure Install Discharge Chute / Chute Rotator Head See FigInstall Chute Deflector Remote Control See Figs Primer OperationKnow Your Snow Thrower Ignition KEYAuger control lever used to engage auger motion throw snow Meets A.N.S.I. Safety RequirementsRecoil auxiliary starter handle used for starting engine HOW to USE Your Snow Thrower StoppingTo Throw Snow See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig Release the auger control lever and shut off the engineBefore Starting the Engine Before Stopping Snow Throwing TipsTo Start Engine If Recoil Starter has FrozenBefore Each USE MaintenanceGeneral Recommendations LubricationCleaning EngineChute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See FigTo Replace Belts See Fig Remove the klik pin and remove wheel from axle To Adjust Cable Tension See FigTo Remove Wheels See Fig CarburetorFuel System StorageOther Engine OILTroubleshooting Limitations and Exclusions HOW to Obtain Service Consumer Wheeled Warranty Chart See Separate Engine Manufacturers or Manufacturers warranty 532 43 59-02 05.20.10 TH