Husqvarna ST 324P Install Traction Drive Control ROD See Figs, Install Auger Control ROD See Figs

Page 6

ASSEMBLY / PRE-OPERATION

INSTALL TRACTION DRIVE CONTROL ROD (See Figs. 3 and 4)

The traction drive control rod is installed on the snow thrower.

1.Remove plastic tie securing traction drive control rod to rotator bracket.

2.With top end of rod positioned under left side of control panel, push rod down and insert top end of rod into hole in traction drive control lever. Snap rod into place by pushing down.

NOTE: Engage lever once and rod should snap into place.

PLASTIC TIE

TRACTION DRIVE

CONTROL ROD

FIG. 3

TRACTION DRIVE CONTROL LEVER

TRACTION DRIVE

CONTROL ROD

FIG. 4

INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)

The auger control rod is installed on the snow thrower.

1.Remove plastic tie securing auger control rod to lower handle. (See Fig. 5).

2.Push down on the auger control rod and bring top end of rod up between the metal console and plastic console cover at right control lever.

3.With control lever in the raised position, insert end of control rod in slot of control lever.

NOTE: Engage lever once and rod should snap into place.

PLASTIC TIE

AUGER

CONTROL

ROD

FIG. 5

AUGER CONTROL LEVER

AUGER

CONTROL

ROD

FIG. 6

6

Image 6

Contents Operator’s Manual Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Uhmw Skid PlatesRemove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Unfold Upper HandleInstall Traction Drive Control ROD See Figs Install Auger Control ROD See FigsInstall Discharge Chute / Chute Rotator Head See Fig Install Chute Deflector Remote Control See FigsCheck Tire Pressure Operation Know Your Snow ThrowerMeets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting the engineHOW to USE Your Snow Thrower StoppingUsing the CLEAN-OUT Tool See Fig To Throw Snow See FigTo Move Forward and Backward See Fig Before Starting the Engine To TransportTo Start Engine Before StoppingSnow Throwing Tips If Recoil Starter has FrozenBefore Each USE MaintenanceGeneral Recommendations LubricationCleaning EngineChute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See FigTo Replace Belts See Fig To Remove Wheels See Fig To Adjust Cable Tension See FigTo Adjust Traction Belt and Auger Belt Tension CarburetorFuel System StorageOther Engine OILTroubleshooting Problem Cause CorrectionConsumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Armor Protected Stamped Deck Shell Example Below Service Notes Service Notes 06/17/2014 AP