OPERATION
MUFFLER
GASOLINE
FILLER CAP
CHOKE
CON-
TROL
SAFETY
IGNITION
KEY
ON / OFF
SWITCH
PRIMER
FUEL
RECOIL (AUXILIARY) STARTER HANDLE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
ELECTRIC
START AUGER
BUTTON CONTROL
LEVER
POWER
CORD
PLUG
CHUTE
DEFLECTOR
DISCHARGE
CHUTE
FIG. 10
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED | DEFLECTOR REMOTE | |
CONTROL LEVER | ||
CONTROL LEVER | ||
|
TRACTION
DRIVE
CONTROL
LEVER
LIGHT
HANDLE
KNOB
MUFFLER
TOOLBOX
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and |
| Drive speed control lever - used to select forward or | |
wrench. |
| reverse motion and speed of snow thrower. | |
Safety ignition key - must be inserted for the engine to |
| Deflector remote control lever - used to change the | |
start and run. Remove when snow thrower is not in use. |
| distance the snow is thrown. | |
Electric start button – used for starting the engine. |
| Traction drive control lever - used to engage power- | |
Recoil (auxiliary) starter handle – used for starting the |
| propelled forward or reverse motion of snow thrower. | |
|
| ||
engine. |
| Auger control lever - used to engage auger motion (throw | |
Primer - pumps additional fuel from the carburetor to the |
| snow). | |
|
| ||
cylinder for use when starting a cold engine. |
| Discharge chute control lever - used to change the di- | |
Choke control - used for starting a cold engine. |
| rection the snow is thrown. | |
| Skid plate - used to adjust height of scraper bar from the | ||
ON / OFF switch - used to STOP the engine. |
| ||
9 | ground. | ||
|