Ariens 921023 quick start Step Four Install Remote Deflector Control Cable

Page 12

Step Four: Install Remote

Deflector Control Cable

1.Connect the barrel cable end to the chute deflector cable anchor before clipping the cable to the discharge chute cable bracket.

2.Route deflector remote cable along the left side of the chute pedestal.

3.Insert the barrel on the cable end into the bracket on left side of chute deflector.

4.Hold seal out of the way while routing the cable through the bracket on the left side of the discharge chute, and then push the cable fitting into the bracket.

5.Push the seal securely over the end on the cable fitting to prevent water from entering the cable.

6.Check deflector travel. Adjust nut on cable end under handlebar to obtain full travel, if necessary see Remote Deflector Control in Owners Manual.

Image 12

Contents Quick Start Guide Step One Assemble Handlebars Step One Assemble Handlebars Unfold Lower Handlebar Step One Assemble Handlebars Attach Upper Handlebar Assembly Step One Assemble Handlebars Attach Control Cables Step One Assemble Handlebars Unfold Upper Handlebar Step One Assemble Handlebars Connect Headlight Wire Harness Step One Assemble Handlebars Install Trigger Cable Step One Assemble Handlebar Step Two Install Discharge Chute Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Control Cable Step Five Check Function of Dual Handle Interlock Step Six Check Track Tension Step Seven Adjust Skid Shoes Step Eight Check Auger Gearcase Oil Step Nine Check Engine Crankcase Oil Step Ten Fill Engine Fuel Tank Step Eleven Starting the Engine Starting Engine / Step a Throttle Starting Engine / Step B Fuel Valve Starting Engine / Step C Key Starting Engine / Step D Choke Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine Additional Resources