Location Hazards, Service Access | Boston Acoustics SUB10F specs

Location Hazards

It is the nature of low-frequency energy (bass) to make objects vibrate. Care should be taken in planning the installation of the in-ﬂoor subwoofer to minimize the risk of room vibration and noise. Do not locate the in-ﬂoor subwoofer close to lamps or furniture that might rattle or vibrate. Some bass energy will be heard in the room below the subwoofer. If the ceiling below is ﬁnished, ceiling ﬁxtures may rattle or vibrate.

It is recommended that in the area where the Sub10F is to be mounted, the subﬂoor is glued to the joists and extra nails are used to secure the subﬂoor. Be sure the joists to which the Sub10F is mounted are securely braced against each other so that the distance between them does not change and they are not able to move or shift (consult local building codes)

Ampliﬁer Requirements & Wiring

The Sub10F must be used with the Boston SA1 Subwoofer Power Ampliﬁer. Use with any other ampliﬁer will result in poor performance. One SA1 Power Ampliﬁer can power up to two Sub10F subwoofers. Only one Sub10F should be connected to each set of terminals on the SA1. If you are installing only one Sub10F, pre-wire so that a second one can be added, but do not connect the extra set of speaker wires to the SA1.

Set the equalization switch (EQ-MODE) on the back of the SA1 ampliﬁer to the “FLOOR” position. We recommend the use of 16-gauge or larger speaker wire with both the Sub10F and SA1.

Service Access

If service is needed, the Sub10F’s woofer can be removed through the access panel on the bottom of the subwoofer. If there is a ﬁnished ceiling below the Sub10F, ideally a door allowing access to the complete subwoofer enclosure, or at minimum, to the Sub10F’s service panel, should be left in the ceil- ing below.