Generac 1403-0 manual Connection Box, Typical Completed Power Transfer System Installation

Page 7

Generac Portable Products Power Transfer System

Figure 11 — Typical Completed Power Transfer System Installation

Connection Box

The installer should use local codes and the following

Figure 12 — Junction Box Installation

 

procedure to install the generator connection box

 

provided with this system.

 

16.Locate and mount the connection box on an outside wall as close as possible to the load center. However, consider household air intake ducting when when locating generator and connection box. A typical power transfer system complete installation is depicted in Figure 11.

17.As shown in Figure 12, mount a junction box at the appropriate distance from the Load Manager™ switches so that both 1/2” flexible conduits can be connected to it.

7

Image 7
Contents Description GeneracGenerator Compatibility Carton ContentsSpecifications UnpackingSum Loads from Data Plates General Safety InformationPlan the Installation Measure Actual LoadsLoad Manager Switch Installation ProcedureMake Sure Wire Detached From BreakerShows a properly-connected Green lead Connection Box Typical Completed Power Transfer System InstallationConnection Box Installation Identifying Circuits Connecting Cord SetInstallation and Load Management Notes Load Manager Schematic Diagram Description Qty Exploded View & Parts ListSwitch To Generator Power Operating ProcedureTesting Switch To Utility PowerCircuit Breakers in Load Manager Switch Troubleshooting Generac Portable Products Limited WarrantyOne Year Limited Warranty Warranty Schedule