Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from tool failure: Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Inspection, Maintenance, and
Cleaning
1.BEFORE EACH USE, inspect the general condition of the Spreader. Check for loose screws, misalign- ment or binding of moving parts, cracked or broken parts, and any other condition that may affect its safe operation.
2.After Use, Never leave material in the Spreader. Pour leftover material back into its bag/container and seal the bag/container tightly.
3.CLEANING AND STORAGE: wash thoroughly to remove all material in the Spreader. Allow the unit to dry. Then store the unit indoors out of children’s reach.
4.NOTE: This Spreader does not require lubrication.
PLEASE READ THE
FOLLOWING CAREFULLY
The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.
TROUBLESHOOTING
Problem |
| Possible Cause(s) |
| Possible Solution(s) |
Unit will not release material. | 1. | Improper use of Adjust Handle. | 1. | Pull Adjust Handle backward to |
|
|
|
| release material. Push forward |
|
|
|
| to stop flow of material. |
| 2. | Improper flow rate setting. | 2. | Make sure Adjust Handle setting |
|
|
|
| is adjusted to that of material |
|
|
|
| manufacturer’s recommended |
|
|
|
| setting. |
| 3. | Wet, or wrong type of materal. | 3. | Unit is designed only for dry, |
|
|
|
| powered, and granular material. |
|
|
|
|
|
Unit releases too much or too little | 1. | Improper flow rate setting. | 1. | Make sure Adjust Handle setting |
material. |
|
|
| is adjusted to that of material |
|
|
|
| manufacturer’s recommended |
|
|
|
| setting. |
Follow all safety precautions whenever diagnosing or servicing the Spreader.
SKU 99623 | For technical questions, please call | Page 9 |