one Lock Nut (24).
(See Figure I.)
HOPPER
(16)
FIGURE I
FLAT
WASHER
(48) LOCK NUT (24)
SHUT OFF PLATE (27)
10.Push down on the Adjust Handle (6) to its lowest position.
(See Figure J.)
| “R” PIN |
| |
| (17) |
|
|
| ADJUST |
| |
| HANDLE |
| |
PINION | (6) |
|
|
|
| ||
SHAFT |
|
| WING |
| FIGURE J | NUT | |
| (10) | ||
|
|
| LOCK NUTS |
|
|
| (24) |
|
|
| “R” PIN (17) |
PUSH FORWARD.
IMPELLER MUST TURN
IN THIS DIRECTION.
12.Pull up on the Adjust Handle (6) to its upper position, making sure the holes in the Hopper (16) and the holes in the Shut Off Plate (27) are 100% open.
(See Figure J.)
13.Adjust the position of the Wing Nut
(10).By doing so, you are able to con- trol the size of the holes you need.
(See Figure J.)
14.Insert the “R” Pin (17) into the Pinion Shaft on the Gear Box and Axle As- sembly (39). Make sure the Impeller
(42)is turning in the correct direction as indicated by the arrow in the illustration.
(See Figure J.)
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before assembly or use of this product.
1.Before operating the Spreader make sure to wear
2.Remove the Screen (14) on the Hopper
(16) and fill the Hopper with the materi- al you wish to apply. Do not exceed 50 pounds of material. Then replace the Screen. (See Figure K, next page.)
3.Refer to the manufacturer’s recom- mended flow rate (0 to 5, typically shown on the bag/container of the material being applied).
Adjust the flow rate on the Gauge and
Lever Assembly (4) to that of the mate-
SKU 99623 | For technical questions, please call | Page 7 |