HOW to Adjust the Spreading

The material spreading is regulated through the regulation lever that moves the opening section on the bottom of the hopper. In order to carry out the regulation, after having consulted the spreading table, acording to the type of material to spread and to the speed of pulling vehicle, it is necessary to move the lever “A” along the graduated scale “E” and locking it in the chosen position with pin “D”.

In order to spread from both sides (ref. I), “A” and “B” levers must be in the same position, connected through grip handle “C”. In order to carry out the spreading only through the left side (ref. II), it is necessary to disconnect the two levers removing the “C” grip handle, to set the lever “B” in the chosen position, given by spreading chart, and to bring the lever “A” towards the higher part (position1) in order to close the shutter of the right side. In oreder to spread only to the right side (ref. III) you have to move lever “B” up, ( in position 1) and regulate the quantity to spread with lever “A”.