7 8
Tighten (rotate) the lock knobs below the Pedestal to a "tight" feel.
Back off the ejector knobs on the Pedestal.
9 Adjust legs until they are level. Adjust the turnbuckle for fine adjustment of level.
The bubble levels will assist you.
Latitude Range Bolts
"Porthole"
The telescope comes set for
10 remove the 4 latitude bolts from each side of the pedestal (8 total) using a supplied hex wrench (see photo above). The pedestal should now be able to swing freely.
Move and line up latitude tick mark with indicator
11 A
Swing the pedestal so that the bolt portholes match up with another set of bolt holes on the underneath plate (there are three sets of bolt holes, one for each latitude range).
Move the pedestal until it lines up your latitude tick mark with the indicator on the latitude scale.
Replace and tighten the latitude bolts. Note: If you are setting for
Looking at or near the Sun will cause irreversible damage to your eye. Do not point this telescope at or near the | 15 |
Sun. Do not look through the telescope as it is moving. |
|