Assembling the NexStar

The NexStar comes completely pre-assembled and can be operational in a matter of minutes. The NexStar and its accessories are conveniently packaged in one reusable shipping carton that contains the following accessories:

•25mm Plossl Eyepiece – 1¼"

•Star Diagonal - 1¼"

•Star Pointer Finderscope and Mounting Bracket

•Visual Back - 1¼" (attached to the optical tube)

•Computerized Hand Control

Start by removing the telescope from its shipping carton and setting the round base on a flat table or surface. It is best to carry the telescope by holding it from the lower portion of the fork arm and from the bottom of the base. Remove all of the accessories from their individual boxes. Remember to save all of the containers so that they can be used to transport the telescope.

Mounting the Telescope to the Tripod

1. Remove the tripod and accessory tray from its box.

2.Pull the legs apart until the legs are fully extended and press it down flat against the ground.

Center Support Rod

Accessory Tray

3.Place the accessory tray over the center support rod so that each arm of the accessory tray is pushing out against the inside of each leg.

4.Tighten with the leg brace locking knob until the leg brace firmly presses out against each leg.

5.The tripod will now stand by itself.

Your tripod has height adjustable legs. To adjust the height of the tripod:

1.Locate the tightening screw on the bottom of each tripod leg.

2.Rotate the knob counterclockwise until the inside portion of the tripod leg slides out.

3.Extend the center portion of the tripod leg to the desired height. Tighten the knob to hold the tripod leg in place.

Locking Knob

Figure 1-1

Positioning

Mounting

Holes

Figure 1-2