Celestron C8-NGT, C10-N manual Installing the Counterweight

	Installing the Counterweight
	Depending on which AST telescope you have, you will receive either two or three counterweights. To install the
	counterweight(s):
1.	Orient the mount so that the counterweight bar points toward the		Counterweight Bar
			Locking Nut
	ground .
			Counterweight
2.	Remove the counterweight safety screw on the end of the		Bar
	counterweight bar (i.e., opposite the end that attaches to the mount).
		Locking Screw

3.Loosen the locking screw on the side of the counterweight.

4.Slide the counterweight onto the shaft (see Figure 2-5).

5.	Tighten the locking screw on the side of the weight to hold the	Counterweight
	counterweight in place.
6.	Replace the counterweight safety screw.
		Safety Screw

Figure 2-5

Attaching the Hand Control Holder

(Advanced GT Models Only)

The Advanced GT telescope models come with a hand control holder to place the computerized hand control. The hand control holder comes in two pieces: the leg clamp that snaps around the tripod leg and the holder which attaches to the leg clamp. To attach the hand control holder:

1.Place the leg clamp up against one of the tripod legs and press firmly until the clamp wraps around the leg.

2.Slide the back of the hand control holder downward into the channel on the front of the legs clamp (see Fig 2-6) until it snaps into place.

Attaching the Slow Motion Knobs (For Non-GT Models Only)

Hand Control

Holder

Leg Clamp

Figure 2-6

The Advanced Series (non-GT models) comes with two slow motion control knobs that allows you to make fine pointing adjustments to the telescope in both R.A. and Declination. To install the knobs:

1.Locate the hard plastic shell under the R.A. shafts.

2.Remove either of the two oval tabs by pulling tightly.

3.Line up the flat area on the inner portion of the R.A. slow motion knob with the flat area on the R.A. shaft (see Fig 2-7).

4.Slide the R.A. slow motion knob onto the R.A. shaft.

9 Figure 2-7