Graco 1522 Attaching the Legs, Attaching the Hanger, Installing Batteries, Using the Cradle, Step

Attaching the Legs

Step 1.

Push oval end of the upper leg sections firmly onto the four plastic pegs. Hold tube vertically while pushing in.

Push leg on completely.

Step 2.

Push the leg tips on the round ends of the lower leg sections. (The other end of each lower leg has a wire.)

Step 3.

Put the wire end of lower leg sections into the round end of the upper leg sections. Push the sections together while twisting lower leg slightly This will ensure a snug fit.

Step 4.

CHECK:

Lift swing as shown. If legs are assembled properly, the legs will dangle from the motor unit and not fall off.

IF LEG FALLS:

Holding leg vertically, push leg firmly up while pushing the motor unit down.

Step 5.

Open the swing legs completely. Snap plastic leg braces onto outside of legs. The plastic pins inside the ends of the braces will fit into the dimples on the legs.

It may be necessary to spread the legs as shown.

Do not use swing without the leg braces.

169-8-99 IS1600 5

Hold

tube

vertically

Flattened

side

Plastic

peg

Round

end (not oval)

Dimple

Push

Push

Attaching the Hanger

Step 1.

With crossbar of hanger toward front of the motor unit, line up holes in hanger brackets with holes on the sides of motor unit.

Step 2.

Insert screws into both brackets as shown. Fasten with acorn nuts using the enclosed hex wrench. Tighten nuts firmly with hex wrench and screwdriver.

Installing Batteries

NEVER INSERT OR REMOVE BATTERIES WITH BABY IN THE SEAT. THEY COULD FALL ON BABY IF DROPPED!

Step 1.

With baby out of swing, open the battery compartment by gently pressing on the lid at the ridged area and lifting the lid.

Step 2.

Insert four “D” cells. Be sure the batteries are put in correctly. (Swing will not run if batteries are put in backwards.)

Step 3.

Snap the lid closed.

Using the Cradle

Not intended for use as a night-time bed or car bed.

REMOVE LAW TAGS FROM CRADLE MATTRESS AND QUILTED SHEET BEFORE USING THIS CRADLE.

Step 1.

Cover soft side of cradle mattress with quilted sheet provided.

6