Pacific Cycle 22-PS245 owner manual Hardware Reference Part Ref. # PSHW10

Pre-Assembled Parts:

•Corner fittings should be attached to the top bar.

•Swing hooks should be in place on the top bar.

•Hardware for the legs should be in place in the corner fitting prongs.

•Hardware for the support bars should be in place on the legs.

Step Illustration	Instructions
1	Remove the hardware from the prong of a
	corner fitting in order to insert one of the
	legs.

2	Align the two sets of holes and replace the
	hardware through the corner fitting prong
	and leg to secure the leg. Do not over
	tighten the screws. After all parts are
	assembled you will need to tighten again.
3	Repeat the process for the other leg on the
	corner fitting.
	Follow the next step before proceeding with
	the legs on the opposite side.
4	One of the top bar sections should have pre-
	assembled hardware. Remove the hardware
	and join the two top bar sections together.
	Then attach the two center legs with the
	bent ends by aligning the holes with those
	of the joined top bar and re-insert the
	hardware. It is recommended that a
	minimum of 2 adults complete this step.
	NOTE: It may be helpful to prop up the
	side of the top bar without the legs about
	one foot off the ground in order to align the
	top bar sections and center legs properly.
	Once the center legs are attached, assemble
	the remaining outside legs and then stand
	up the swing set frame.

5	Remove the hardware from the middle
	section of a leg. Match up the holes of the
	mid-leg and support bar and re-insert the
	hardware through both. Repeat the process
	for the opposite side and center legs. It
	may be necessary to pull both legs towards
	each other in order for the holes to align
	properly.

Hardware Reference Part Ref. #: PSHW10

Part Ref. #: PSHW10

Part Ref. #: PSHW10

Part Ref. #: PSHW10

Part Ref. #: PSHW10

Part Ref. #: PSHW12

6 ©2006 Pacific Cycle, Inc.