Graco 1602 Attaching the Legs, Attaching the Hanger Tubes and Seat, Step, Push leg on completely

Attaching the Legs

Step 1.

Push oval end of the upper leg sections firmly onto the four plastic pegs. Hold tube vertically while pushing in.

Push leg on completely.

Step 2.

Push the leg tips on the round ends of the lower leg sections. (The other ends have a wire.)

Step 3.

Put the wire end of lower leg sections into the round end of the upper leg sections.

Push the sections together while twisting lower leg slightly. This will ensure a snug fit.

Hold tube vertically

Flattened

side

Plastic peg

Wire end

Round

end (not oval)

Attaching the Hanger Tubes and Seat

Step 1.

Move seat back fully forward onto seat armrests.

The seat back must overlap the armrests.

OVER	Seat back	OVER
A		A
A		A

Armrest

Step 2.

Slide hanger tubes into armrests of seat as shown.

Step 3.

Step 4.

CHECK:

Lift swing as shown. If legs are assembled properly, the legs will dangle from the motor unit and not fall off.

IF LEG FALLS:

Holding leg vertically, push leg firmly up while pushing the motor unit down.

Step 5.

Open the swing legs completely. Snap plastic leg braces onto outside of legs. The plastic pins inside the ends of the braces will fit into the dimples on the legs.

It may be necessary to spread the legs as shown.

Do not use swing without the leg braces.

Dimple

Push

Push

Insert two pin screws through seat armrests into the holes in the hanger tubes and tighten securely.

Step 4.

Insert the hanger tubes into the hanger brackets as shown. Metal buttons should pop out and lock upon full insertion.

CHECK that the hanger tubes are secure in hanger brackets by pulling firmly on them.

132-7-99 IS1651 5 6