Step 2.
Snap handle and hinges together to lock. Be sure handle is locked into the plastic hinges.
Step 3.
Place cradle in hanger.
Be sure handle notches are seated in the hanger.
Hanger
Adjusting the Handle
To bring carrier handle from resting position into position for carrying or swinging, first set the carrier down. Then push down on center of handle, and rotate the handle forward until it clicks into the locked position.
Push down on center of handle
Notch
To return the handle to resting
Push down on center
Starting the Cradle
Step 1.
Place your child in the cradle.
Step 2.
Set the CONTROL switch between the low and center positions. Your cradle will swing properly only in the lower range.
Step 3.
Push ON/OFF switch to the “on” position.
Step 4.
PUSH CRADLE TO START. BE SURE YOU PUSH IT UP HIGH ENOUGH FOR THE MOTOR TO GET A GOOD START.
NOTE: Draping a small blanket over side of cradle will slow the swinging motion.
Using the Carrier
position, first set the carrier down. Then push down on center of handle, and rotate the handle backward until it clicks into place.
NOTE: It is normal for the handle to seem loose in the resting position.
Using the Tray
Unlatch the tray by squeezing the two latches under the tray at the same time, and lift up tray. Be careful not to let tray hit your baby when lifting or closing tray.
To latch tray, push down firmly.
Tray must be latched at all times when baby is in the swing.
of handle
Lift carrier in and out of swing.
Do not adjust the handle while carrier is on swing.
Different uses for infant carrier...
Cuddler | Carrier | Feeder |
| ...or as a Rocker. |
|
| 7 |
|
Adjusting the Stand
To change recline of the carrier, squeeze the adjustment wire and move to desired position.
To adjust for rocking, move the adjustment wire to the highest position.
Do not change recline with baby in carrier.
Be aware that infant move- ment or rocking may cause the carrier to move on a table.
8