Classe Audio CT-2300, CA-2300 owner manual Specifications

Page 30

30

Specifications

All tests un-weighted and 500kHz measurement bandwidth (except SNR).

n

Frequency response

1Hz – 80kHz, -3dB

n

Output power

300W rms into 8Ω (24.8 dBW)

 

 

600W rms into 4Ω (24.8 dBW)

 

Harmonic Distortion

Both channels driven

n

<0.002% @ 1kHz balanced

 

Peak Output Voltage

<0.004% @ 1 kHz single ended

n

150V peak to peak, 53V rms no load

 

 

136V peak to peak, 48V rms into 8Ω

n

Input Impedance

50kΩ balanced / single ended

n

Voltage gain

29 dB balanced / single ended

n

Input level at clipping

1.88V rms balanced / single ended

n

Intermodulation Distortion

>90dB below fundamental into

 

 

8Ω balanced / single ended

 

 

>90dB below fundamental into

 

 

4Ω balanced / single ended

n

Signal-to-noise ratio

-116dB at peak output into 8Ω

 

 

Measurement Bandwidth: 22kHz

n

Output Impedance

 

0.015Ω @ 1kHz

n

Standby power consumption

 

<1W @ 230V

n

Rated power consumption

763W @ 1/8th power into 8Ω

n

Overall Dimensions

CA-2300 Width: 17.50” (444mm)

 

CT-2300 Width (including faceplate): 19” (483mm)

 

CT-2300 Width (excluding faceplate): 17” (432mm)

 

CA-2300 Depth (excluding connectors): 17.52” (445mm)

 

CT-2300 Depth (excluding connectors): 18.625” (473 mm)

 

 

CA-2300 Height: 8.78” (223mm)

 

Gross weight

CT-2300 Height: 6.97” (177mm)

n

CA-2300: 100lbs (45.36 kg)

 

Net weight

CT-2300:

109lbs (49.5kg)

n

CA-2300:

88lbs (39.92 kg)

 

Mains voltage

CT-2300:

89lbs (40.5kg)

n

Specified on rear panel

For more information, see your Classé dealer, or contact:

B&W Group Ltd.

5070 François Cusson

Lachine, Quebec

Canada H8T 1B3

Telephone

+1 (514) 636-6384

FAX

+1 (514) 636-1428

Internet:

http://www.classeaudio.com

email:

cservice@classeaudio.com

Classé and the Classé logo are trademarks of B&W Group Ltd., Worthing U.K. All rights reserved. AMX® is a registered trademark of AMX Corporation of Richardson, TX. All rights reserved. Crestron™ is a trademark of Crestron Electronics, Inc. of Rockleigh, NJ. All rights reserved. Control 4™ is a trademark of Control 4 Corporation of Saltlake City UT. All rights reserved.

Image 30
Contents CA-2300 / CT-2300 Two-Channel Amplifier Class Important Safety Instructions Contents Word about installation Welcome to the Classé familyUnpacking and Placement Operating voltage Warm up/break-in period Please read this manual… Special Design Features Extraordinary longevityExtensive listening tests Robust protection Front Panel Standby button & LED indicatorFlashing blue on power-up = On dim redPage Rear Panel Balanced XLR InputSingle-Ended RCA Input Speaker OutputsClassé CAN-Bus Control Ports IR Input and OutputUSB Control Port DC Trigger Input and OutputRS 232 Control Port AC Mains InputPage Installation CT-2300 stand-alone installation instructions32 X 9/16 philips pan head screws 32 X 3/4 screws Make your speaker connections Configure your amplifier turn-on delay/amp noMake your preamp/processor connections Double-check all your connectionsClassé Delta or CT Series Products Install the front panel CT-2300 onlyCAN-Bus Category 5 Network CablesAny combination of models in any order Using CAN-Bus CAN-Bus shared features Following CAN-Bus features are shared by all modelsFollowing CAN-Bus features are model specific PlayLinkAmp info Event log Care and Maintenance No sound, and Standby LED is blinking red TroubleshootingNo sound, and Standby LED is not lit Amplifier keeps shutting offAC mains fuse is blown Standby LED is flashing quicklySpecifications Dimensions CA-2300CT-2300 Page North America 514