7. HOW TO DISPLAY
A. When displaying printed material.
1, Connect power of the unit. Blue back image appears on the monitor and then image of the printed material will be displayed.
2.Put the printed material below the lens and operate Zoom switch watching TV monitor according to the size of the material. (if focus is out after zooming operation, push AUTO FOCUS switch once. If the correct focus is not obtained yet, push Focus switch to adjust focusing manually.)
B. When displaying three-dimensional object.
Caution
When displaying shooting area without conversion lens focus may not work to get focus. When displaying the shooting area, conversion lens is necessary to be installed.
8. | TROUBLESHOOTING | ||
SYMPTOM |
| CAUSE | REMEDY |
No Power |
| Plug not connected to outlet | Connect plug to outlet |
|
| No good connection of AC | Connect AC Adaptor right |
|
| Adaptor |
|
No Image |
| Power is OFF | Connect plug to outlet |
|
| Poor connection of video cable | Connect video cable right |
Focus is Out |
| Subject is too close to lens | Subject should not come up |
|
|
| more than 100mm above stage |
|
|
| surface |
Dark Image |
| No good Bright adjustment | Adjust Brightness by remote |
|
|
| control |