APPENDIX B SSP-60 Mode Chart
Below are the available modes (subject to change) and the active speakers in each case. The subwoofer is not included in the table since it is active if selected in the speaker setup and if any of the active speakers are set as “small”.
MODE | Signal Type | Processing | Output from Speakers |
Mono | Dolby Digital EX | Mono downmix | C |
| Dolby Digital 5.1 | Mono downmix | C |
| Dolby Digital 2/0 | Mono downmix | C |
| Mono downmix | C | |
| Mono downmix | C | |
| DTS 3/2 | Mono downmix | C |
| PCM | Mono downmix | C |
| Analog | Mono downmix | C |
Stereo | Dolby Digital EX | Stereo downmix | L, R |
| Dolby Digital 5.1 | Stereo downmix | L, R |
| Dolby Digital 2/0 | Not applicable | Not applicable |
| Stereo downmix | L, R | |
| Stereo downmix | L, R | |
| DTS 3/2 | Stereo downmix | L, R |
| PCM | No processing | L, R |
| Analog | No processing | L, R |
Stereo 96 | Dolby Digital EX | Not applicable | Not applicable |
| Dolby Digital 5.1 | Not applicable | Not applicable |
| Dolby Digital 2/0 | Not applicable | Not applicable |
| Not applicable | Not applicable | |
| Not applicable | Not applicable | |
| DTS 3/2 | Not applicable | Not applicable |
| PCM | Not applicable | Not applicable |
| Analog | A/D 24/96 | L, R |
Direct | Dolby Digital EX | No processing | L, R, C, LS, RS |
| Dolby Digital 5.1 | No processing | L, R, C, LS, RS |
| Dolby Digital 2/0 | No processing | L, R |
| No processing | L, R, C, LS, RS, LB+RB | |
| No processing | L, R, C, LS, RS | |
| DTS 3/2 | No processing | L, R, C, LS, RS |
| PCM | Not applicable | Not applicable |
| Analog | Not applicable | Not applicable |
Dolby Pro Logic / | Dolby Digital EX | Not applicable | Not applicable |
Pro Logic II Movie & | Dolby Digital 5.1 | Not applicable | Not applicable |
Pro Logic II Music | Dolby Digital 2/0 | Dolby PL / PLII | L, R, C, LS, RS |
| Not applicable | Not applicable | |
| Not applicable | Not applicable | |
| DTS 3/2 | Not applicable | Not applicable |
| PCM | Dolby PL / PLII | L, R, C, LS, RS |
| Analog | Dolby PL / PLII | L, R, C, LS, RS |
Note: LB+RB indicates that a single rear (back) surround signal is played by both rear channels.
Continued on following page
30