Eiki LC-XB10 Connecting Projector, Terminals of Projector, Video Input Jack Audio Input Jacks

CONNECTING PROJECTOR

TERMINALS OF PROJECTOR

This projector has input and output terminals on its back for connecting computers and video equipment. Refer to figures on pages 11 to 13 and connect properly.

S-VIDEO INPUT JACK	AUDIO INPUT JACKS
Connect the S-VIDEO	Connect the audio output
output from video	from video equipment to
equipment to this	these jacks.
jack. (Refer to P13.)	(Refer to P13.)
	● When the audio output
	is monaural, connect it
	to L (MONO) jack.

COMPUTER IN 1		VIDEO	Pb / Cb – Pr / Cr
DVI - I	R – AUDIO IN – L (MONO) Y –
	S – VIDEO	AUDIO IN	R – AUDIO OUT – L
		COMPUTER

VIDEO INPUT JACKS

Connect the composite video output from video equipment to VIDEO/Y jack or connect the component video outputs to VIDEO/Y, Pb/Cb and Pr/Cr jacks. (Refer to P13.)

RESET

AUDIO OUTPUT JACKS

Connect an external audio amplifier to these jacks.

(Refer to P12, 13.)

RESET BUTTON

This projector uses a micro processor to control this unit, and occasionally, this micro processor may malfunction and need to be reset. This can be done by pressing RESET button with a pen, which will shut down and restart the unit. Do not use RESET function excessively.

COMPUTER IN 2 / MONITOR OUT USB CONTROL PORT

CONTROL PORT CONNECTOR

When controlling the computer with Remote Control of this projector, connect the mouse port of your personal computer to this connector. (Refer to P12.)

COMPUTER INPUT / MONITOR

OUTPUT TERMINAL

This terminal is switchable and can be used as computer input or monitor output. Set the terminal up as either Computer input or Monitor output properly before using this terminal. (Refer to P12, 36.)

Note:This terminal outputs analog signal from

COMPUTER IN 1 DVI-I terminal only.

COMPUTER INPUT (DIGITAL/ANALOG)

Connect computer output (Digital / Analog DVI-I type) to this terminal. (Refer to P12.)

COMPUTER AUDIO

INPUT JACK

Connect the audio output (stereo) from computer to this jack. (Refer to P12.)

USB CONNECTOR (Series B)

When controlling the computer with Remote Control of this projector, connect USB port of your personal computer to this connector. (Refer to P12.)

11