Eiki LC-XB10 owner manual Appendix, Lamp Replacement, Reset the Lamp Replace Counter

APPENDIX

LAMP REPLACEMENT

LAMP REPLACE

When the life of the Projection Lamp of this projector draws to an end, the LAMP REPLACE indicator lights yellow. If this indicator lights yellow, replace the projection lamp with a new one promptly.

This indicator lights yellow when the life of the projection lamp draws to an end. Replace the Projection Lamp with a new one promptly.

TOP CONTROL

	G
RNIN
WA	P.
TEM

			P
	M
A					E
L
				C
			A
		L
	P
E
R

VOLUME –

INPUT IMAGE MENU

		CAUTION
Allow a projector to cool, for at least 45 minutes before	For continued safety, replace with a lamp assembly of
you open Lamp Cover. The inside of a projector can	the same type.
become very hot.	Do not drop a lamp assembly or touch a glass bulb! The
	glass can shatter and may cause injury.

Follow these steps to replace the lamp assembly.

1	Turn off the projector and disconnect the AC plug. Allow the
	projector to cool for at least 45 minutes.
2	To remove the Lamp Cover, remove the screw with a
	screwdriver.
3	Loosen 3 screws with a screwdriver and pull out the Lamp
	Assembly by grasping the Handle.
4	Replace the Lamp Assembly with a new one and tighten the 3
	screws back into position. Make sure that the Lamp Assembly is
	set properly. Replace the Lamp Cover and tighten the screw.
5	Connect the AC Power Cord to the projector and turn on the
	projector.
6	Reset the Lamp Replace Counter.
	Refer to “LAMP REPLACE COUNTER” on the next page .

LAMP COVER

SCREW

LAMP	SCREW	HANDLE
ASSEMBLY

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the following information to the dealer.

●	Model No. of your projector	:	LC-XB10
●	Replacement Lamp Type No.	:	POA-LMP53
			(Service Parts No. 610 303 5826)

38