Eiki LC-XG200, LC-XG100 Basic Operation, Turning on / OFF Projector, Turning on Projector

BASIC OPERATION

TURNING ON / OFF PROJECTOR

TURNING ON PROJECTOR

1	Complete peripheral connections (with Computer, VCR, etc.)
	before turning on projector. (Refer to "CONNECTING
	PROJECTOR" on pages 11~13 for connecting the equipment.)
2	Connect the projector's AC Power Cord into an AC outlet. LAMP
	Indicator lights RED, and READY Indicator lights GREEN.
	NOTE : When “On start” function is ON, this projector is turned
	on automatically by connecting AC Power Cord to an
	AC outlet. (Refer to page 37.)
3	Press POWER ON-OFF button on Top Control or on Remote
	Control Unit to ON. LAMP Indicator dims, and Cooling Fans

start to operate. Preparation Display appears on a screen and count-down starts. The signal from PC or Video source appears after 30 seconds.

Current Input position and Lamp mode status are also displayed on screen for 5 seconds. (Refer to "LAMP MODE" on page 37.)

Input position and

Lamp mode status

Computer 1

30

Preparation Display disappears after 30 seconds.

TURNING OFF PROJECTOR

1	Press POWER ON-OFF button on Top Control or on Remote
	Control Unit, and a message "Power off?" appears on a screen.
2	Press POWER ON-OFF button again to turn off the projector.
	LAMP Indicator lights bright and READY Indicator turns off.
	After the projector is turned off, Cooling Fans operate (for 90
	seconds). During this "Cooling Down" period, this appliance
	cannot be turned on.
3	When projector has cooled down, READY Indicator lights
	GREEN again and you can turn the projector on. After cooling

down completely, disconnect AC Power Cord.

TO MAINTAIN THE LIFE OF LAMP, ONCE YOU TURN PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.

Power off?

Message disappears after 4 seconds.

When “Power Management” function is ON, projector detects signal interruption and turns off Projection Lamp automatically. Refer to “Power management” on pages 37.

When WARNING TEMP. indicator flashes red, projector is automatically turned off. Wait at least 5 minutes, conform READY indicator will light green and projector may be turned on by pressing POWER ON-OFF button.

When both WARNING TEMP. and READY indicators to flash, a projector cannot be turned on by pressing POWER ON-OFF button. In this case, follow procedures below:

1.Disconnect AC Power Cord from an AC outlet.

2.Turn a projector on again. (Refer to steps 2-3 of TURNING ON PROJECTOR on this page.)

When WARNING TEMP. indicator continues to flash, follow procedures below:

1.Disconnect AC Power Cord from an AC outlet.

2.Check Air Filters for dust accumulation.

3.Clean Air Filters. (See "AIR FILTER CARE AND CLEANING" section on page 41.)

4.Turn a projector on again. (Refer to steps 2-3 of TURNING ON PROJECTOR on this page.)

If WARNING TEMP. indicator should still continue to flash, contact sales dealer where you purchased this projector or service center.

19