Eiki LC-X3/X3L instruction manual For this information, contact to your authorized dealer

CONNECTING THE PROJECTOR

CONNECTING AN IBM-COMPATIBLE DESKTOP COMPUTER

(DIGITAL INPUT CONNECTION)

NOTE: This connection need optionally sold Graphic Accelerator Board.

For this information, contact to your authorized dealer.

Before using with digital connection, install (Plug in) Graphic Accelerator

Board into PCI bus slot of the computer and set up the computer

COMPUTER	following instructions in the Graphic Accelerator Board package.
	MONITOR CABLE
	(NOT PROVIDED)

GRAPHIC

ACCELERATOR

BOARD

INSTALL (PLUG) INTO PCI BUS SLOT

ANALOG OUTPUT

DIGITAL OUTPUT

DIGITAL FLAT PANEL CABLE (NOT PROVIDED)

SERIAL PORT	PS/2 PORT	COMPUTER	R	AUDIO CABLE
		AUDIO OUTPUT	L	(NOT PROVIDED)
INPUT	INPUT
					COMPUTER
			COMPUTER		INPUT 1
			AUDIO INPUT 1 R	L	(DIGITAL)

		USB 1	CONTROL PORT 1	AUDIO 1			ANALOG		DIGITAL		IN-1
				R	L	(MONO)					COMPUTER
MOUSE CABLE FOR		USB 2	CONTROL PORT 2	AUDIO 2		R	G	B	H	V	IN-2
PS/2 PORT				R	L	(MONO)					COMPUTER
(PROVIDED)
		R/C JACK	SERIAL PORT	AUDIO OUT				ANALOG RGB			OUT
				R	L
											COMPUTER
MOUSE CABLE FOR	CONTROL PORT
SERIAL PORT	OUTPUT 1
(PROVIDED)
SERIAL PORT CABLE		SERIAL
		PORT
(NOT PROVIDED)		OUTPUT
					COMPUTER
	AUDIO CABLE				AUDIO OUTPUT
	(NOT PROVIDED)

AUDIO

INPUT		SPEAKER
L	R	OUT	Speaker (L)	Speaker (R)
		L

Amp.

R

NOTE: When connecting the cable, the power cords of both the projector and the external equipment should be disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched on.

16