Eiki LC-X3/X3L instruction manual Troubleshooting, Cleaning the Projection Lens

APPENDIX

CLEANING THE PROJECTION LENS

Follow these steps to clean the projection lens:

1.Apply a non-abrasive camera lens cleaner to a soft, dry cleaning cloth. Avoid using an excessive amount of cleaner.

Abrasive cleaners, solvents or other harsh chemicals might scratch the lens.

2.Lightly wipe the cleaning cloth over the lens.

3.When you don't use the projector, replace the lens cover.

TROUBLESHOOTING

Before calling your dealer or service station for assistance, check the matters below once again.

1.Make sure you have connected the projector to your equipment as described in section "CONNECTING THE PROJECTOR" on pages 11 ~ 22.

2.Check cable connections. Verify that all computer, video and power cords are properly connected.

3.Verify that power is switched on.

4.If the projector still does not display an image, re-start the computer.

5.If the image still does not display, unplug the projector from the computer and check the computer monitor's display. The problem may be with your graphics controller rather than with the projector. (When you reconnect the projector, remember to turn the computer and monitor off before you power up the projector. Power the equipment back up in order of: Projector and computer)

6.If the problem still exists, check the following chart.

Problem:		Try these Solutions:
No power.	●	Plug the projector into an AC outlet.
	●	Turn the MAIN ON/OFF switch to ON.
	●	Press the POWER ON/OFF switch to ON.
	●	Be sure the READY INDICATOR light is ON.
	● Wait 90 seconds after the projector is turned OFF before turning the projector
		back on.
	NOTE: After pressing the POWER ON/OFF button to OFF. The projector functions
		as indicated.
	1.	The LAMP POWER indicator will light and the READY indicator will turn off.
	2.	After 90 seconds, the READY indicator will light green again and the projector
		may be turned on by pressing the POWER ON/OFF button.
	● Check temperature warning indicator. If the indicator flashes red, the projector
		cannot be turned on.
		(See "BASIC OPERATION" section on page 32).
	● Check the projection lamp.
	● Replace the lamp cover. (Check the interlock switch inside of the lamp cover.)
Image is out of focus.	● Adjust the focus.
	● Make sure the projection screen is at least 4.9' (1.5 m) from the projector.
	● Check the projection lens to see if it needs cleaning.
	NOTE: Moving the projector from a cool temperature location to a warm
		temperature location may result in moisture condensation on the lens. In
		such an event, leave the projector OFF and wait until condensation
		disappears.

53